handle bars

[Mr B]

I've got a pair of Cyclesmiths 12 inch apehangers to fit to my RKC. They're 1 1/4" diameter with reduced diameter in the centre and the ends. My question is....to accomodate the switch housings and the grips, I need at least 7 inches in length. The reduced diameter is only 5 inches long, so it will mean that 2 inches of grip will hang off the end of the bars without any support inside it. Is this going to be ok or should I make a couple of 2 inch extensions and weld them to the end of the bars, and sand them down to original diameter.
I hope you understand what I'm going on about.

Brian.

 

[masha]

Re: handle bars

i understand what your on about brian ,i have very wide beach bars on my dyna on the throttle side you dont notice the shortness but on clutch side its just noticeable but no problem if you feel better add the two inch . gaz