Dredger
Club Member
As I'm getting on in years and recently purchased a street glide which is more than awkward to back out of my workshop, I have just ordered materials and arranged for water cutting of the turntable top.
The top is to be 2.2 metres in diameter and will use a large 'lazy Susan' bearing rated for a 1 tonne load. If anyone has built a turntable before I would be interested in any comments or good outcomes as this is a little experimental for me. I have opted for 6mm steel durbar plate and will probably get everything galvanised. The under carriage design is still in my head but I'm working on two options and might even fit it flush with the wood workshop flooring.
Not a cheap project but hope this will keep me riding for years to come. All ideas welcome.
The top is to be 2.2 metres in diameter and will use a large 'lazy Susan' bearing rated for a 1 tonne load. If anyone has built a turntable before I would be interested in any comments or good outcomes as this is a little experimental for me. I have opted for 6mm steel durbar plate and will probably get everything galvanised. The under carriage design is still in my head but I'm working on two options and might even fit it flush with the wood workshop flooring.
Not a cheap project but hope this will keep me riding for years to come. All ideas welcome.